The technician working on the bike was happy because he did the job in about an hour and a half versus about 4 hours for a full tear down. After finishing up the entire reassembly of the bike it, it was test-ridden and we had fixed the problem. “On this job, we only needed to replace the valve stem seal as the customer had issues with lots of smoke coming out of the tail pipe. Repeat the process until all springs or seals have been taken care of. You can now replace the valve spring or seals. This is done to prevent the valve from falling.ĥ – Using standard wrenches, compress the valve spring, remove the keepers and retainers. Tighten fasteners in place.Ĥ – Using standard shop air (90-120 PSI), pressurize the cylinder through the spark plug hole. Position the large hole over the valve spring with the two threaded studs pointing at the same angle as the valve stem. ![]() Remove any other brackets that could interfere with mounting the Valve Spring Compressor plate.ģ – Mount the Valve Spring Compressor base on the cylinder head. Remove the gas tank according to manufacturer’s instructions.Ģ – Fully expose the valve springs by removing the complete rocker box assembly, including the lower rocker arm cover. Remove the rider’s seat and disconnect the negative battery terminal. Here’s how it works:ġ – Place the transmission in gear with rear wheel firmly on the working surface and front wheel locked. Remove the gas tank and rocker box assembly and you’re ready to get to work. You can use it to replace broken valve springs, install high performance springs, remove and replace valve guide seals all without completely disassembling the motorcycle. We call it the V-Twin On-the-Engine Valve Spring Compressor (Order No. It’s simply one of the coolest tools we’ve seen in a long time. Dont force the screw, as this can damage the tools threads. If the puller screw wont drive in all the way, back it out, realign the puller, and drive in the screw again. The puller screw threads into the same screw hole that accepts the faucet handle screw.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |